Anerka Four Roll Bending Simulator

Settings

px / mm

Select Machine Type

HR-4 HMR-4 HRR-4

Machine Parameters

Model Name

Bending Lenght L2 [mm]

Top Roll Diameter (Ød) [mm]

Pre-Bending Capacity (Ødx1,5) [mm]

Bending Capacity (Ødx3) [mm]

Large Rolling Capacity (Ødx5) [mm]

Max. Pass Through [mm]

Select Material

Material

Plate thickness t [mm]

Yield strength σy [MPa]

Ultimate tensile σUTS [MPa]

Young's modulus E [MPa]

Springback radius Rf [mm]

Control & Results

Gap between top & bottom rolls [mm]

Side Rolls Position [mm]

Slider

Ri (inner radius) [mm]

Inner R (Rf) • after springback

Side Roll Max. Stroke [mm]

ØDCR (top roll) [mm]

ØDCP (bottom roll) [mm]

ØDA (side roll) [mm]

xFA (X-axis to pivot O) [mm]

yFA (Y-axis to pivot O) [mm]

xBA (X-axis to base pin) [mm]

yC (Y-axis to base pin) [mm]

dvc (Y-axis to rectilinear axis ref.) [mm]

teta (Side roll axis angle) [deg]

RadA (Cylinder Pivot arm lenght) [mm]

RA (Bearing Pivot arm lenght) [mm]

Alpha1 (Angel between RadA & RA) [deg]

ML min limit [mm]

www.anerka.com

The calculations in this simulator are based entirely on theoretical data and may produce different results in real applications. Copying or republishing without permission of Anerka Makina San.Tic.Ltd.Şti is prohibited.